WarmlyYours Infinity - Manual (Page 3)

1. Affixing the Towel Warmer to the Wall
Step 1
Draw a diagram of the preferred location of the brackets and the electrical
connection on the towel warmer box to create a template (see Step 2 for
template instructions). At least two of the four brackets must be attached
directly to a stud.
The Infinity Plug-In model must be installed less than 6 feet (183cm) from
a properly grounded outlet to ensure the plug can reach. Make sure to
measure the distance from where to plug is attached to the towel warmer to
the electrical outlet. Do NOT use an extension cord to make the connection
between the towel warmer plug and outlet.
Step 2
A. Attach tubing into desired positions on the towel warmer (see pages 5-8
for bracket assembly).
B. Place towel warmer on the box (or a large sheet of paper) and lay on a
flat surface with brackets facing downwards.
C. Mark the location of the following:
• The electrical collar (hardwired model only)
• The location of the brackets
D. Use the template as a guide to mark the wall with the correct locations
of the four brackets, ensuring the following:
• The electrical collar is lined up with the center of the electrical
box (hardwired model only). Plug-in model must be installed less
than 6 feet (183cm) from properly grounded outlet. Do NOT use
an extension cord.
• At least two of the brackets are lined up with a wall stud.
• The towel warmer is level.
Step 3
Install the brackets onto the wall. Use the drywall anchors that are
supplied for the brackets that are not being installed into a stud. Refer to
Diagrams A and B.
2