Rockwell Automation 20P PowerFlex DC Drive - Frame C AC Current Transducers - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C AC Current
Transducers
What This Kit Includes
•
Two AC Current Transducers (with signal wires)
•
Two Screws and washers
•
Static strap
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
•
Nut driver or wrench
Phillips
®
is a registered trademark of Phillips Screw Company.
What You Need to Do To install the AC Current Transducers:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective covers
❐ Step 3: Remove the existing AC Current Transducers
❐ Step 4: Install the new AC Current Transducers
❐ Step 5: Replace the protective covers and document the change
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.