Barco R5976934 - Manual (Page 40)

4. Controlling
4-4 ___________________________________________________________Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008
4.2 Terminology of the RCU controls
1 Function keys
F1 Source selection
F2 PIP control setting
F3 Switch between master source and PIP source
F4 In VGA mode: White balance
F5 Shows the RS232 address of the monitor
2 ADJ ADJUST key, to enter the OSD
3 Address key has no function for this monitor
4 Selection key Switch the light sensor on/off
5 PAUSE Change baud rate of the serial interface
6 Standby stand by button, to start the monitor when the power switch is switched on and to
switch off the monitor without switching off the power switch.
7 Mute Switch off and on the sound (audio)
8 Help Indicates the resolution of the input video signal
9 Digit buttons 0-9: have no function for this monitor
10 Audio controls To control volume, balance, bass and treble of the audio signal
11 Picture controls Except for brightness and contrast, these keys have no function for this monitor
12 PHASE Adjust the phase of the signal
13 Freeze Auto adjust
14 TEXT Switch on/off the 4:3 mode
15 ENTER to confirm an adjustment or selection
16 Cursor Keys to make menu selections in the OSD.
RCU
cursor key up
cursor key down
cursor key right
cursor key left
Use the cursor keys up or right for increasing a value.
Use the cursor keys down or left for decreasing a value.
17 EXIT to leave a menu or the OSD
18 RC operating
indication lights up when a button on the remote control is pressed. (This is a visual indicator
to check the operation of the remote control)
How to use the RCU?
Point the front of the RCU directly at the screen.
When using the IR remote control, make sure you are within the effective operating distance
(30m, 100ft in a straight line). The remote control unit will not function properly if strong light
strikes the sensor window or if there are obstacles between the remote control unit and the IR
sensor.