Vertical, Horizontal, Combination of signals for main image and pip/pap – Barco R5976934 User Manual

Page 59

Advertising

5. The On Screen Display (OSD)

Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008

______________________________________________________________________________________

5-17

5.3.3.3 Vertical

Vertical can be adjusted in the range from 0 to 255.

RCU

Push button (1: top most)

• Use the up and down cursor keys to navigate to

the Vertical

• Press 5 and 6 to navigate to Vertical

• Use the left and right cursor keys to in-

crease/decrease the value in steps of 1
The current value is indicated.
(increase: move down/decrease: move up)

• Use 3 and 4 to increase/decrease the value in

steps of 1
The current value is indicated.
(increase: move down/decrease: move up)

The value is applied without any further action.

5.3.3.4 Horizontal

Horizontal can be adjusted in the range from 0 to 255.

RCU

Push button (1: top most)

• Use the up and down cursor keys to navigate to

the Horizontal

• Press 5 and 6 to navigate to Horizontal

• Use the left and right cursor keys to in-

crease/decrease the value in steps of 1
The current value is indicated.
(increase: move right/decrease: move left)

• Use 3 and 4 to increase/decrease the value in

steps of 1
The current value is indicated.
(increase: move right/decrease: move left)

The value is applied without any further action.

5.3.4 Combination of signals for main image and PiP/PaP

The following table lists the combination of signals for input 1 (main input) and input 2 (PiP/PaP). Not all combi-
nations are possible; some cause disturbances or result in images which are not properly scaled.

Input 1

Input 2

Comment

DVI

only possible for low resolutions,

higher resolutions cause an error message
(Pixel rate > 110MHz),

not recommended with Barco Transform H
system.

HD-SDI 1 or HD-SDI 2

VGA

S-Video or Composite or Com-
ponent

VGA