Rockwell Automation 1560E SMC Flex Smart Motor Controller - Manual (Page 105)

Chapter
7
Diagnostics
Overview
This chapter describes the fault diagnostics of the MV SMC-Flex
controller. Further, this section describes the conditions that cause
various faults to occur.
Protection Programming
Many of the protective features available with the SMC-Flex controller
can be enabled and adjusted through the programming parameters provided.
For further details on programming, refer to the Motor Protection section
in Chapter 4, Programming.
Fault Display
The SMC-Flex controller comes equipped with a built-in three-line,
16-character LCD. The LCD displays the fault message on the first line,
the fault code on the second line, and the fault description on the third line.
FAULTED
FAULT #27
COMS LOSS P2
Figure 7.1 – Fault Display
Note: The fault display will remain active as long as control power is
applied. If control power is cycled, the fault will be cleared, the
controller will re-initialize, and the display will show a status of
"Stopped".
Important: Resetting a fault will not correct the cause of the fault
condition. Corrective action must be taken before resetting
the fault.
1560E-UM050B-EN-P - June 2013