Rockwell Automation 1492 WinABMS Marking System Software - Manual (Page 20)

3-4 Initial Setup
4. Replace aluminium base plate and holders with the blue
composite base plate. Attach blue composite base plate to the
plotter by inserting the 2 locating pins into the holes in the
plotter bed.
5. Install pen in the top slot of the carousel.
To setup the Cat. No. 1492-PLTKIT plotter:
1. Use the communications cable (provided with Cat. No.
1492-PLTKIT) to connect the computer RS–232 port to the serial
communication connector on the plotter. COM1 through COM4
are supported
.
ATTENTION
!
The power cord supplied with the plotter is shielded.
Do not use other power cords. Failure to use the
supplied power cord may result in electromagnetic
interference with other equipment.
Power
Switch
DIP
Switches
RS-232
Serial Communication
Port
Power Cord
Connector