Rockwell Automation 1492 WinABMS Marking System Software - Manual (Page 32)

Using WinABMS Software 4-5
The text can be deleted, added to, or replaced with new text in the text
window. The text position can also be shifted from top, center, or bottom and
from left, center, or right by use of the appropriate tools.
Additional lines of text can be added by pressing the Enter/Return key.
To enter marker text:
1. Double click on the marker where you wish to enter text.
2. Enter the text in the text window located in the upper right corner.
Use the BACKSPACE key to delete a single character.
3. When done, select another marker by double clicking on it or by
pressing Tab to go to the next marker.
To adjust font size and width:
1. Select the markers you wish to adjust, then click on Marker under the
Format heading.
2. When the Format Text Dialog Box appears, enter the font size and
width you desire.
Note: It is recommended that you use a font size of 6 pt or greater, and a font
width of 70% or greater.
3. Click on OK.
OR
1. Select the markers you want to adjust, then select the pop-up triangle on
the tool bar.
2. When the different font sizes appear, either select the pre-assigned
number or type in the font size.
OR
1. Select the markers you want to adjust, then right click.
2. When the Format Text Dialog Box appears, enter the font size and
width you desire.
To delete marker text:
1. Select the markers with the text you wish to delete.
2. Click on Delete under the Edit heading, click on the Cut Tool, or use
the DELETE key.