Rockwell Automation 1492 WinABMS Marking System Software User Manual
Page 36
Using WinABMS Software 4-9
3. Make sure the ink is flowing properly from the pen tip by drawing some
test lines (refer to the instructions included with the pen).
4. Install pen in the top slot of the carousel.
5. Click on Plot under the File heading or click on the Plot Tool.
To plot one marker card:
1. Repeat steps 1-4 under To Plot An Entire File.
2. Select the card that will be plotted, then click on Plot Card under the
File heading.
Note: Markers plotted with disposable ink pens can be handled in 5 minutes.
For best results, the markers should not be installed for 24 hours.
Note: Remove the entire branch from the marker card before trying to remove
individual markers. Once the branch is free, then separate the individual
markers.
Install pen in the top slot of the
carousel
Marker Card
Spacer
Base Plate