Rockwell Automation 1329I Integrated AC Drive/Motor, Series A - Manual (Page 11)

Step 1 - Identify Your Unit 1-5
1329I-5.0 Integrated Drive/Motor — January, 1999
1.2.4 Operating the Unit Using the Local Operator Controls
➊ If the unit is using a preset speed reference (see Section 7.4.1), pressing the or key will have
no effect on unit operation.
Important: If the local operator controls are disconnected from or connected to the
unit after power up, the unit will stop due to a non-resettable fault. Refer
to Chapter 11 for information about faults.
Desired Action User Steps
Start the unit. Press the green key.
Stop the unit. Press the red key.
Change the direction of motor rotation. Press the key.
Clear faults or abort Auto Restart
sequence. Press the key.
Decrease the speed reference. ➊ Press the key until the speed reference
displayed is the desired value. The longer the
key is held down, the faster the value decreases.
Display the current speed
reference Press the or key once.
The display returns to indicating speed in RPM or
percent load after three to five seconds. Holding
down either key will change the speed reference.
Display the speed in RPM No action required; speed in RPM is the default
display based on status of terminal 12 (see Section
7.4). If the
or keys are not pressed for
several seconds, the display returns to indicating
actual motor speed in RPM.
Display percent load Close contact on terminal 12 (see Section 7.4)
Increase the speed reference. ➊ Press the key until the speed reference
displayed is the desired value. The longer the
key is held down, the faster the value increases.
RESET