Rockwell Automation 1329I Integrated AC Drive/Motor, Series A - Manual (Page 15)

Step 2 - Plan the Installation 2-3
1329I-5.0 Integrated Drive/Motor — January, 1999
2.1 Wire Routing Guidelines
The 1329I unit is shipped from the factory with plastic conduit plugs installed. These
plugs must be removed. Before wiring, replace these plugs with appropriate 3/4-inch
NPT connectors having a similar enclosure rating. After wiring, seal unused routing
holes using permanent, user-supplied 3/4-inch NPT plugs. Seal all threaded connections.
Route the power and control wiring as shown in Figure 2.3.
Figure 2.3
Wire Entry Locations
DC+
DC-
DBR
T/L3
S/L2
R/L1
PE
Control Signal Wiring AC Input Power Wiring
AC Input Power Wiring Control Signal Wiring