Rockwell Automation 1609-ENET Ethernet Network Card Quick Start User Manual
Page 13
Advertising
Rockwell Automation Publication 1609-QS002A-EN-P - May 2014
13
Ethernet Mode Setup
Chapter 2
5. Use the PING utility to check the connection between your PC and the ENET card. From Windows, launch the
Command Prompt and enter ping 192.168.1.100. You should receive replies. Note: Make sure your computer is on
the same network as the UPS with a static IP address.
6. Open RSLinx Classic and create an Ethernet driver. Go to the Communications toolbox and select Configure
Drivers.
Advertising