Rockwell Automation 1770-M12 Mass Storage Systems - Manual (Page 17)

Installing Your Mass Storage System
Chapter 3
3Ć2
To mount your mass storage system, follow these steps:
1. Place the mass storage system on a flat surface.
2. Remove both front corner inserts (Figure 1.3) using a small screwdriver.
Double-faced tape holds this corner insert to the mass storage system.
Figure 1.3
Remove Both Front Corner Inserts
Front corner insert
11958
The handles are optional hardware. Skip step 3 if you do not want this option.
3. Connect each mounting bracket with each handle and secure with two
flat-head machine screws (Figure 1.4).
4. Line up each mounting bracket over the corner of the mass storage system.
5. Secure two (per mounting bracket) self-tapping screws into the mass
storage system (Figure 1.5).
6. Place the mass storage system onto your rack. Allow four inches of clear
space between the back of the mass storage system and the wall. This
allows the fan to circulate filtered air to cool your mass storage system.
7. Secure the mounting bracket onto your rack.