Rockwell Automation 1770-M12 Mass Storage Systems - Manual (Page 48)

Care of Your Mass Storage System
Appendix A
AĆ8
6. Gently, but firmly, push the micro-floppy into the opening of the drive
until you release it without it popping out.
ATTENTION: Do not turn the power off before you remove the
micro-floppy. Damage to the micro-floppy and loss of data can
occur.
To remove your micro-floppy, follow these steps (Figure 1.23):
Figure 1.23
How to Remove a MicroĆfloppy from a Mass Storage System
Press this pushbutton;
the microĆfloppy will eject
11980
1. Press the eject pushbutton located at the lower right hand corner of the
disk drive.
2. Remove the micro-floppy.
3. Place the micro-floppy into its storage sleeve and store it in a vertical
position inside the original box.
How to Remove Your
MicroĆfloppy