Rockwell Automation 1738-ACNR ArmorPoint ControlNet Adapter, Series A - Manual (Page 5)

Publication 1738-IN016B-EN-E - March 2005
ArmorPoint ControlNet Adapter, Series A 5
Configure Autobaud
The adapter cannot reconfigure an I/O module that you previously
configured to operate at a fixed baud rate. When you reuse a
ArmorPoint I/O module from another ArmorPoint I/O system,
configure the module to autobaud before using it with the adapter.
For More Information
Refer to the ArmorPoint I/O ControlNet Adapter Release Notes,
publication 1738-RN001, online at URL
http://literature.rockwellautomation.com.
Mount the Adapter
and I/O Base
To mount the ArmorPoint adapter on a wall or panel, use the screw
holes provided in the adapter.
A mounting illustration for the ArmorPoint adapter with I/O bases is
shown below.
Install the mounting base as follows:
1. Lay out the required points as shown above in the drilling
dimension drawing.
2. Drill the necessary holes for #8 (M4) machine or self-tapping
screws.
3. Mount the adapter using #8 (M4) screws.
4. Ground the system using the ground lug connection in the I/O
base. (The ground lug connection is also a mounting hole.)
43769
4.02 in.
102 mm
1.81 in.
46 mm
Adapter
1.9 in.
47.2 mm
2.0 in.
50 mm
0.87 in.
22 mm
2.0 in.
50 mm
0.87 in.
22 mm
2.0 in.
50 mm