Bosch Single Door - Manual (Page 27)

27
The heightĆadjustable feet at the front and rear can all
be adjusted from the front.
Front: with openĆended wrench 1 /
2
" (SW13)
Rear: with 5 /
16
" (8 mm) hex nut driver
via flexible shaft.
d CAUTION d
Never use a cordless screwdriver!
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting
the height, align this mark at a height of 1¼" (32 mm)
above the floor.
q Unscrew the heightĆadjustable feet until the mark
on the base has reached the indicated guide
dimension (1¼" / 32 mm).
i It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
q Align the furniture fronts with the spirit level.
i Note:
- Do not twist or jam the appliance inside the cavity!
When unscrewing the heightĆadjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
- The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
- If using a wooden beam as an alternative antiĆtip
device according to point 6 of this installation
manual, rotate the appliance all the way towards
the wooden beam.
13. Attaching the appliance to the
top of the cavity
q Screw the attachment plate lugs (top) to the
overhead furniture/fixtures.