Rockwell Automation 1738-AENTR Armorpoint 2 Port Enet Adapter - Manual (Page 12)

12 ArmorPoint I/O 2-Port EtherNet/IP Adapter, Series A
Publication 1738-IN028B-EN-E - February 2010
Red Unrecoverable fault has occurred:
- self-test failure (Flash checksum
failure at power up, ramtest failure
or EEPROM checksum failure at cycle
power).
- firmware fatal error.
Replace device.
Network Activity
Status Description Recommended action
Off No link established with Port 1 or
Port 2. Verify network cabling, and
correct, as needed.
Green - Link established with Port 1 and/or
Port 2 at 100 Mbps.
- Link established with Port 1 and
Port 2. One port at 100 Mbps and one
port at 10 Mbps.
None.
Flashing
green - Transmit or receive activity present
on Port 1 and/or Port 2 at 100 Mbps.
- Transmit or receive activity present
on Port 1 and/or Port 2. One port at
100 Mbps and one port at 10 Mbps.
None.
Yellow Link established with Port 1 and/or
Port 2 at 10 Mbps. None.
Flashing
yellow Transmit or receive activity present
Port 1 and/or Port 2 at 10 Mbps. None.
Adapter Status (Continued)
Status Description Recommended action