Barco R9010310 - Manual (Page 130)

B. Dust filter Replacement
Image B-2
Slide out front dust filter
Image B-3
Insert front dust filter
B.2 Dust filter on the back side
Necessary tools
• A flatblade screwdriver of 5 mm
• Allen key 5 mm
How to replace ?
1. Turn on the back panel the 3 lock screw a quarter turn counter clockwise. (image B-4)
2. Take off the back panel and lay it on its back side.
3. Loosen the four screws holding the cover plate by turning a few terns. (image B-5)
4. Slide the cover plate (a) to the middle until the screws matches the big holes.
5. Take off the cover plate.
6. Pull out the dust filter. (image B-6)
7. Insert a new dust filter
8. Place the cover plate over the 4 screws and slide to the outside.
9. Tighten the 4 screws.
10.Mount the back cover and turn the 3 lock screws a quarter turn clockwise.
126 R5976801 SLM R9+ 20/10/2004