Barco R9010310 - Manual (Page 95)

8. Installation Mode
8.3 800 peripheral
Overview
• Defining the output module of the RCVDS05.
• Defining the Infrared Communication protocol
• CLO using Comm 800
8.3.1 Defining the output module of the RCVDS05.
Which module are available?
When a RCVDS05 is connected to the projector, the type of output module of this RCVDS05 has to be defined in the 800 peripheral
menu.
• standard output module
• 5 cable output module
Defining the output module
To define the output module:
1. Push the cursor key ↑ or ↓ to highlight 800 Peripheral. (menu 8-5)
2. Press ENTER to select.
3. Push the cursor key ↑ or ↓ to highlight Output module. (menu 8-6)
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONTRAST ENHANCEMENT
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-5
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
CLO USING COMM800 [YES]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-6
8.3.2 Defining the Infrared Communication protocol
Which protocols are available?
When a peripheral is connected to the ’Comm Port’, the communication can be in PPM or RC5.
The type of communication can be set to :
•
PPM
• RC5
Defining the communication protocol.
1. Push the cursor key ↑ or ↓ to highlight 800 Peripheral. (menu 8-7)
2. Press ENTER to select.
3. Push the cursor key ↑ or ↓ to highlight Infrared. (menu 8-8)
4. Press ENTER to select.
5. Press ENTER to toggle between [PPM] or [RC5].
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONTRAST ENHANCEMENT
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-7
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
CLO USING COMM800 [YES]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-8
R5976801 SLM R9+ 20/10/2004 91