Rockwell Automation 1440-TB-H XM-947 Dynamic Vibration Terminal Base - Manual (Page 13)

XM-947 Dynamic Vibration Terminal Base 13
Publication GMSI10-IN027A-EN-P - May 2010
3. Hook the lip on the rear of the terminal base onto the top of the DIN
rail, and rotate the terminal base onto the rail.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a
screwdriver or similar device to open the locking tab, press down on
the terminal base until flush with the DIN rail and release the locking
tab to lock the base in place.
5. Connect the wiring for the XM-947 terminal base unit as shown
under Wiring later in this document.
Interconnecting Terminal Base Units
Follow the steps below to install another terminal base unit.
1. Position the terminal base on the 35 x 7.5mm DIN rail (A).
2. Make certain the side connector (B) is fully retracted into the base
unit.
3. Slide the terminal base unit over tight against the neighboring terminal
base. Make sure the hook on the terminal base slides under the edge
of the terminal base unit.
IMPORTANT
Terminal base units are mounted left to right on the DIN rail.