Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manual (Page 5)

XM Dynamic Measurement Module 5
Publication ICM-IN002A-EN-P - March 2009
European Hazardous Location Approval
European Zone 2 Certification (The following applies when the product bears the
Ex or EEx Marking)
This equipment is intended for use in potentially explosive atmospheres as defined by
European Union Directive 94/9/EC and has been found to comply with the Essential Health
and Safety Requirements relating to the design and construction of Category 3 equipment
intended for use in potentially explosive atmospheres, given in Annex II to this Directive.
Compliance with the Essential Health and Safety Requirements has been assured by
compliance with EN 60079-15 and EN 60079-0.
ATTENTION
This equipment is not resistant to sunlight or other sources of UV radiation.
WARNING
This equipment must be installed in an enclosure providing at least IP54
protection when applied in Zone 2 environments.
WARNING
This equipment shall be used within its specified ratings defined by
Allen-Bradley.
WARNING
Provision shall be made to prevent the rated voltage from being exceeded by
transient disturbances of more than 40% when applied in Zone 2
environments.
WARNING
This equipment must be used only with ATEX certified backplanes.