Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manual (Page 8)

8 XM Dynamic Measurement Module
Publication ICM-IN002A-EN-P - March 2009
Install the Module
The module mounts on a 1440-TBS-J terminal base unit. We recommend that
you insert the module after you have connected the wiring on the terminal
base unit. Refer to the XM Dynamic Measurement Terminal Base Installation
Instructions, publication
ICM-IN003 , for wiring information.
ATTENTION
The 1440-DYN02-01RJ module is compatible only with the 1440-TBS-J
terminal base unit. The keyswitch on the terminal base unit should be at
position 1 for the module.
Do not attempt to install the 1440-DYN02-01RJ module on other
terminal base units.
Do not change the position of the keyswitch after wiring the terminal
base units.
ATTENTION
To comply with the CE Low Voltage Directive (LVD), all connected I/O must be
powered from a source compliant with the following: Safety Extra Low Voltage
(SELV) or Protected Extra Low Voltage (PELV).
To comply with UL restrictions, this equipment must be powered from a source
compliant with the following: Class 2.
WARNING
If you insert or remove the module while backplane power is on, an electrical
arc can occur. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
WARNING
If you connect or disconnect wiring while the field-side power is on, an
electrical arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous
before proceeding.