Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manual (Page 9)

XM Dynamic Measurement Module 9
Publication ICM-IN002A-EN-P - March 2009
1. Make certain the keyswitch (D) on the terminal base unit (E) is at
position 1 as required for the module.
2. Make certain the side connector (B) is pushed all the way to the left.
You cannot install the module unless the connector is fully
extended.
3. Make certain that the pins on the bottom of the module are straight so
they will align properly with the connectors in the terminal base unit.
4. Position the module (A) with its alignment bar (G) aligned with the
groove (F) on the terminal base.
5. Press firmly and evenly to seat the module in the terminal base unit.
The module is seated when the latching mechanism (C) is locked into
the module.
6. Repeat the above steps to install the next module in its terminal base.
C
E
D B
F
31886
G
A