Balboa Water Group Dolphin II - Manual (Page 15)

15
Unitech 0240
Vector 0045
Video Concepts 0045
Videomagic 0037
Videosonic 0240
Viewsonic 1972
Villain 0000
Wards 0000, 0035, 0060, 0048, 0047,
0081, 0042, 0240, 0072
White Westinghouse 0209, 0072
XR-1000
0000, 0035, 0072, 0035
Zenith 1479, 0000, 0039, 0033, 0209
ZT Group 1972
PROGRAMMING CABLE
CONVERTER (OR SATELLITE
RECEIVER) CONTROL
Locate the brand name of your Cable Converter (or
Satellite Receiver) in the Setup Codes For Cable
Converters (or Setup Codes For Satellite Receivers)
section starting on the next page, and write it in the
appropriate space.
Cable Converter Brand:
or
Satellite Receiver Brand:
The brands are listed in alphabetical order
with the most popular codes listed first. You
will use one of these codes to reprogram the
Dolphin to operate your Cable Converter or
Satellite Receiver.
1. Turn on the Cable Converter or the
Satellite Receiver.
2. On the Dolphin, press CBL/SAT once. Press and
hold SETUP until the LED blinks twice, then
release SETUP.
3. Enter the first four-digit code for your
Cable Converter or Satellite Receiver. If you
perform this procedure correctly, the LED will
blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, repeat steps 2-3 and try
entering the same code again.
4. Aim the Dolphin at your Cable Converter or
Satellite Receiver and press POWER once. The
unit should turn off. If it does not respond,
repeat steps 2-4, trying each code listed for
your brand until you find one that works. If it
still does not work, try searching for the code
(see Searching For Your Code on page 25).
5. Write your Cable Converter or Satellite Receiver
code in the boxes below for future reference.
QQQQ
NOTE: Remember to use the Dolphin to operate
your Cable Converter or Satellite Receiver, press
CBL/SAT first.