Balboa Water Group Dolphin II - Manual (Page 7)

7
SPA ADDRESSING
The Dolphin II technology is capable of eliminating
interference that may occur when neighboring spa
owners use Dolphin remotes.
Important: This feature will not function if your
spa is controlled by RF via the Command Center,
or if your spa is controlled by IR.
1. If you notice the pumps, blower or light on
your spa operating when your neighbor uses his
Dolphin remote, check your spa manual to see
if this feature is available on your system.
If so, follow the procedure described in your
spa manual to enter a spa address into your spa.
2 After entering the spa address into the spa, you
are now ready to enter a set up code into the
Dolphin Remote.
3. Press the SPA button on the Dolphin once
4. Press and hold SETUP until the LED blinks
once. It will then blink twice.
5. Enter one of the set up codes below:
Set Up Code Spa Address
0000 0 (no address)
0008 1
0080 2
0088 3
0800 4
0808 5
0880 6
0888 7
6. Write your Set Up code and Spa Address in the
boxes below for future reference.
QQQQ-Q
7. If the code is entered correctly, the LED will
blink twice.
Battery Installation
(from previous page)