Balboa Water Group Dolphin II - Manual (Page 33)

33
2. Run the IR Signal Extension Cord to the
device that is not in line-of-sight of the IR/RF
Command Center.
3. Using the supplied double-sided tape, attach
the IR Signal Extension Cord so that its LED
is over or next to the IR sensor of your home
theater device.
4. Test the installation by again taking the Dolphin
into another room in your home. Select a
device key (e.g., TV) and press it once. Then
press POWER once.
The IR/RF Command Center will convert the RF
signal from the Dolphin into an IR signal and
transmit that signal through the IR Signal Extension
Cord to turn on your device (e.g., TV).
If it does not turn on, try repositioning the LED
until the device can be controlled, then reattach
the LED.
Optimizing IR/RF Command Center
Reception
Here are some adjustment tips for optimizing the
operation of your IR/RF Command Center:
• Aim the Dolphin toward the room where the
IR/RF Command Center is located.
• Do not position the IR/RF Command Center
near metal objects, such as heat ducts. Metal
can block RF signals.
• Make sure the batteries in the Dolphin are
fully charged. Try replacing them if you are not
sure (see Installing Batteries on page 7). Weak
batteries will affect the signal range.
• Make sure that the Dolphin is not being
affected by other RF transmissions (e.g., garage
door openers, cordless telephones, etc.).
*Distance Note for Command Center
Note: The Dolphin Remote will operate the
Command Center at distances up to 100 feet in
an open field. Range will be adversely affected by
metal structures, objects blocking the signal path,
antenna orientation or extension, radio frequency
interference from other sources, or weak batteries
in the Dolphin Remote.