Bendix Commercial Vehicle Systems EC-16 ANTILOCK CONTROLLER 4/08 - Manual (Page 28)

28
SECTION X - TESTING TRACTION CONTROL DASH LAMP
NO
YES
REPLACE EC-16 ™
CONTROLLER
YES
NO
1
2
3
C2
K J H G F E D C B A
REPAIR OR REPLACE WIRE
HARNESS AND RETEST
VEHICLE VOLTAGE
DETECTED?
WITH IGNITION OFF, REMOVE 30 PIN
CONNECTOR FROM EC-16 ™ CONTROLLER.
TURN IGNITION ON AND
CHECK FOR VEHICLE VOLTAGE AT
TERMINAL C2.
REPLACE TRACTION DASH LAMP WITH
KNOWN GOOD UNIT. REPEAT "INITIAL
START-UP PROCEDURE"
30 PIN CONNECTOR
IS THIS THE SECOND TIME TO
THIS POINT?
START HERE