Bendix Commercial Vehicle Systems SB-7 AIR DISC BRAKE - Manual (Page 28)

28
9 Guide Pin Bushing replacement
(for “Axial- and Radial Disc Brake”)
Remove Caliper (see Section 10.1)
Remove Sleeve (5) and inner Boot (9) (see Section 8).
9.1 Brass Bushing (7) replacement
Remove old Sleeve (5).
Pull out Bushing (7) with Tool (D) (Order No. II19254).
If Caliper has no groove (see arrow)
(Note: Groove is always located on the
inboard side)
Pull in new Brass Bush (7) with Tool (D).
If Caliper has a groove:
Pull in new Brass Bush (7) with Tool (D).
To prevent longitudinal displacement, use
Tool (F) (Order No II36797) to create
dents in bushing.
Check contact area of Brass Bushing (7) for burrs.
Remove burrs.
Grease Bushing with white Grease RENOLIT HLT2
(Order No II14525).
Insert new Sleeve (5).
Note:
The Guide Pins Kit contains new Sleeves (4) & (5)
and new Caliper Bolts (39) & (40) (see Section 1.2
and 1.4).
M+P-KN-030
6
4
7 D
VF 00127/16
9.2 Rubber Bushing (6) replacement
Remove old Sleeve (4)
Pull Rubber Bushing (6) out of bore.
Check bore for corrosion, clean, if necessary coat bore
with Corrosion protection paint (e.g. Zinc spray).
Note:
Grease new Rubber Bushing (6) inside and outside with
green Grease SYNTHESO GL EP 1 (Order No
II32793).
7
D
VF 00127/17