Bendix Commercial Vehicle Systems SB-7 AIR DISC BRAKE - Manual (Page 30)

30
WARNING!
Hold the Caliper only on the exterior.
Never insert your fingers between
the Caliper and Carrier!
IMPORTANT!
permitted. Use only Genuine Bendix
service Exchange Calipers. Disassembly
of the Caliper will void any
Warranty Claim.
Remove Caliper from Carrier.
10.2 Caliper fitting
Check the Part No. on the label (arrow, Figure above
right) to ensure that you have selected the proper
replacement Caliper.
Note:
Service Exchange Calipers have a blue label.
The Service Exchange Caliper has a plastic cap or an
adhesive tape in the area of the Actuator attachment.
Remove the cap or tape after installing the Caliper
(see arrow).
Note:
The service exchange Caliper includes sealing and
guiding elements. The Pads are not included.
FD00114
10.2.1 Caliper with Rubber Boot (10)
Locate the Caliper to the Carrier.
Screw-in Caliper Bolts (39 and 40) and tighten to
210
+18
ft. lbs. (285
+25
Nm) (use only new parts).
Check that the Caliper slides easily.
Check the position of the Inner Boot (9) on the
Sleeve (5).
Check Adjuster function (see Section 5.2)
If necessary, use a new Rubber Boot (10).
Ensure grease-free seating of the Rubber Boot (10)
on the Caliper (1)
FD00116
31
39
10
40
31a 10a
FD00113
M+P-KN-027
5
9
58
WARNING!
Hold the Caliper only on the exterior.
Never insert your fingers between
the Caliper and Carrier!
Opening or dismantling the Caliper is not