Bendix Commercial Vehicle Systems SmarTire Trailer-Link Op Manual User Manual

Page 26

Advertising
background image

26

In some cases, the supplied 6ft harness may not be sufficient for your

installation. If this is the case, there is an optional 15 ft SmarTire Trailer-Link

TPMS Harness Part No: K075869 available. Please contact your distributor

to order this part.

Step 7. Route the 4-pin diagnostic LED line to the side of the trailer or slider

and secure the line every foot with zip ties. Ensure the Bendix diagnostics

LED Cap part number K075866 is placed over the end of the diagnostic

connector, P4 in Figure 17 when not used with the Maintenance Hand tool.

Connect the trailer to power and watch for the LED to light up briefly to confirm

the SmarTire Trailer-Link ECU is functional. Refer to the blink code table in

Section C for more information.

Step 8. If needed, adjust the Cold Inflation Pressure (CIP) of each axle using

the SmarTire

®

Maintenance Hand tool (090.0011) and diagnostics harness

part number K092501 as described in Section 3.1 to complete the installation.

If the optional trailer warning lamp is not installed, please use the supplied

dielectric grease and fill the trailer lamp output connector (P5 in Figure 17)

with grease to protect it from corrosion. For instructions on how to install the

optional trailer warning lamp, continue to step 9.

Optional Step 9. Using the lamp output

connector (P5 in Figure 17) a trailer lamp may

also be installed at the nose of the trailer to

provide trailer TPMS alerts regardless if the

tractor is equipped with a SmarTire TPMS

unit. Extend a power line from the connector

to the lamp (standard 12-24V lamp with max

one (1) Amp draw can be used, not provided

by Bendix) and ground the lamp to the trailer

chassis at its mounting point. Place the

provided Trailer Lamp alert sticker underneath

the trailer lamp. See Section C for blink codes.

Figure 18

CAUTION: A 5-Amp fuse is included with all SmarTire Trailer-Link

TPMS harnesses. If the fuse needs to be replaced, use a maximum

5-Amp fuse to protect the SmarTire Trailer-Link ECU.

Advertising