Bendix Commercial Vehicle Systems SmarTire Trailer-Link Op Manual - Manual (Page 29)

29
6. When the Cold Inflation Pressure (CIP) values have been adjusted to
the desired setting, press and hold the Return button for 3 seconds
until the programming screen bellow is displayed.
Figure 21
7. Using the SmarTire Trailer-Link ™ programming cable (Part Number
K092501), connect the tool to the SmarTire Trailer-Link harness.
Figure 22
8. Press the Check button to initiate programming. You may also press
the Return button to return to the CIP adjustment screen or press the
button to return to the main menu.
9. Once programming has been initiated, the following screen is shown:
Figure 23
10. After successful programming, the following screen is shown:
Figure 24
11. Press the Return button to exit to the main menu.
12. In the case of a programming error, the following screen is shown:
Figure 25
If this occurs, ensure the SmarTire Trailer-Link ECU is powered and the
connection from the tool to the SmarTire Trailer-Link harness is correct.
Press the Check button to retry the operation, press the Return
button to return to the CIP adjustment screen in step 5, or press the
button to abort the programming and return to the main menu.