Bendix Commercial Vehicle Systems SmarTire Trailer-Link Op Manual User Manual
Page 43
43
7.1.3 Q: When the Gauge first powers up, the alert lamp is blinking and
a triangle with an exclamation mark is displayed. A few minutes later
the alert clears and the display returns to normal. Was there an alert?
A: During the start up sequence, the
Gauge may clear itself of a previous alert
condition or issue a momentary alert if a
tire sensor has not reported in.
Figure 46
As soon as the tire sensors report their latest readings and they do not
constitute an alert condition, the Gauge will clear the alert.
Ensure that the user keeps an eye on the particular alert until it is cleared.
If the alert does not clear itself, the user may indeed have an alert condition
that needs to be checked further. Updating the given tire position with new
information by using the LF Tool or Maintenance Hand tool (press “Initiate”),
would clear the alert faster, unless an alert condition does exist or the sensor
is malfunctioning.