Bendix Commercial Vehicle Systems ACom Diagnostics V.6.7 - Manual (Page 24)

24
Installation Test requirements
The chart below indicates which tests are available for an Electronic Control Unit (ECU). If there is a YES
next to the test name, that specific test is required in order to complete the Installation Test. If there is a
“NO” shown for a test, that test is not required in order to complete the Installation Test. If there is an “N/A”
shown for a test, this indicates that the ECU does not support that specific test. As a result, the test will not
appear in the Installation Test list. For the wheel speed sensors, at least one of the two sensor tests is
required – indicated by the word “ONE” in the chart. Bendix recommends that the full sensor test be run,
although the simple sensor test is an acceptable option.
All the tests in the table below refer to Bendix ® EC-60 ™ Controllers.