Page 11 – Blizzard Lighting ProKontrol MH(Rev A) User Manual
Page 11
Page 11
ProKontrol MH Manual Rev. A
© 2013 Blizzard Lighting, LLC
3.5 System Functions
3.5.1 Resetting The System
WARNING: This will reset the controller to its factory defaults. ALL PROGRAMS AND
SETTINGS WILL BE ERASED!
1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “02. Reset factory”.
3. Press <ENTER> to confirm.
4. Rotate the PAN wheel to select YES or NO.
5. Press <ENTER> to confirm or <ESC> to return to the main menu.
3.5.2 Delete All Fixture Patches
1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “03. delete all Fixture patch”.
3. Press <ENTER> to confirm.
4. Rotate the PAN wheel to select YES or NO.
5. Press <ENTER> to confirm or <ESC> to return to the main menu.
3.5.3 Data Back-Up to USB Memory Stick
1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “06. Data back up”.
3. Press <ENTER> to confirm.
4. Insert a USB memory stick to the USB port.
5. Rotate the PAN wheel to select YES or NO; press <ENTER> to confirm.
6. Press a number button to store the back-up file. Up to 16 files can be
backed up, respectively stored in number 1-16 buttons. If the LED indicator
of a number button is on, it means there is back-up file in this position.
7. Press the <ESC> button to return to the main menu.
3.5.4 Load Data From USB Memory Stick
1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.
2. Rotate the PAN wheel to locate “07. data load.”
3. Press <ENTER> to confirm.
4. Make sure your USB memory stick is in the USB port.
5. Rotate the PAN wheel to select YES or NO; press <ENTER> to confirm.
6. Press a number button to load the back-up file. Up to 16 files can be
backed up, respectively stored in number 1-16 buttons. If the LED indicator
of a number button is on, it means there is back-up file in this position.
7. Press the <ESC> button to return to the main menu.
3.5.5 Send Fixture Update File (RDM Fixtures Only)
Through the DMX cable, send fixture firmware code.
1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.
2. Insert a USB memory stick to the USB port.
3. Rotate the PAN wheel to locate “08. Send fixture Update file”.
4. Press <ENTER> to confirm.
5. Rotate the PAN wheel to locate the file to send.
6. Press <ENTER> to start sending.
7. Repeat Step 4 and 5 to send another file.
8. Press the <ESC> button to exit.