Blizzard Lighting ProKontrol MH(Rev A) - Manual (Page 14)

Page 14
ProKontrol MH Manual Rev. A © 2013 Blizzard Lighting, LLC
4. Press the <FIXTURE> button (indicator on).
5. Select the desired fixture(s) with the number buttons (1-16) and the
PAGE button (PAGE A: 1-16, PAGE B: 17-32).
6. Move the faders and/or wheels to adjust the DMX output values.
Scenes and/or movements can also be included.
7. Press the <REC> button to save the current step.
8. Repeat Step 4-5 to edit a new step while in <CHASE> mode, you
can rotate the PAN wheel to browse all the steps. You can also press
the <INSERT> button to insert a step. Repeat Step 3-6 to edit another
scene.
9. When all the steps are edited, press the <CHASE> button then
press the number button to save (the same button as step 3).
10. Press and hold the <REC> button for 2 seconds to exit Editing
Mode.
3.9.3 Run Scenes
1. Press the <SCENE> button (indicator on).
2. Press the number button(s) to activate the scene(s).
3. Note: Scenes may be stacked. The last scene takes precedence.
3.9.4 Run Chases
1. Press the <CHASE> button (indicator on).
2. Press the number button(s) to activate the chase(s). Maximum 5
chases can be output simultaneously.
3. Press <RUN MODE> to select a run mode:
• AUTO: Chases run in the sequences of the numbers.
• MANUAL: Rotate the PAN wheel to run step by step, forward or
backward.
MUSIC: The chases will be activated by sound. To adjust the sensitivity of
sound activation in MUSIC mode, press and hold and then rotate the TILT
wheel. When two or more chases are running simultaneously, the chase that is
adjustable shows a blinking LED indicator. To adjust another chases, press the
corresponding number button for 2 seconds until its LED indicator blinks, then it
is ready for adjustment. The last activated chase will always be the one that is
adjustable.
Use the PAN wheel to adjust the wait time, 0.10-10m00s, and use the TILT
wheel to adjust the fade time, 0.05-30.0s.
3.9.5 Fade In/Out Time of the Color Channels
1. Press the <FIXTURE> button (indicator on)
2. Press and hold the <FIXTURE> button, then rotate the PAN wheel
to adjust the fade in/out time of the color channels. Each fixture can
be set with individually fade in/out settings. Fade in/out time can also
be set to enabled/disabled.