Page 13 – Blizzard Lighting ProKontrol MH(Rev A) User Manual
Page 13
Page 13
ProKontrol MH Manual Rev. A
© 2013 Blizzard Lighting, LLC
6. Press <SWAP> to switch between the adjustable parameters.
3.9 Scenes and Chases
3.9.1 Scene Editing
Channels and movements can be edited in a static scene.
1. Press and hold the <REC> button for 2 seconds to enter Editing
Mode.
2. Press the <FIXTURE> button (indicator on).
3. Select the desired fixture(s) with the number buttons (1-16) and the
PAGE button (PAGE A: 1-16, PAGE B: 17-32).
4. Move the faders and/or wheels to adjust the DMX output values.
Movements can also be included.
5. Press the <REC> button to get ready to save.
6. Press the <SCENE> button and then press a number button to save
the scene. There are two pages (Page A and B) to save the scenes.
Once a scene is saved successfully, all the LED indicators will blink 3
times.
7. Repeat Step 3-6 to edit another scene.
8. Press and hold the <REC> button for 2 seconds to exit Editing Mode.
3.9.2 Chase Editing
Channels, scenes and movements can be edited in a chase.
1. Press and hold the <REC> button for 2 seconds to enter Editing
Mode.
2. Press the <CHASE> button (indicator on).
3. Select a number button for the chase.
Movement Range
Pan: 0-100% TL: 0-100%
Adjusts the movement size.
Movement Offset
Pan: 0-255 TL: 0-255
Adjusts the movement center point.
Movement Speed
0.00-30.00s
Adjusts the time needed to complete one step.
Delay Level
Level: 00-25
Steps to offset each fixture.