2 running a chase, 3 checking a chase, 4 edit a chase (copy a bank into a chase) – Blizzard Lighting SnoKontrol (Rev B) User Manual
Page 13: 5 edit a chase (copy a scene into a chase), 6 edit a chase (insert a scene into a chase), 7 delete a scene in a chase, Running, Chase, Checking, Delete
SNOKONTROL Manual Rev B.
Page 13
3.4.2 Running A Chase
1.
Press a <CHASE> button then press the <AUTO/DEL> button.
2.
Adjust the chase speed by tapping the <TAPSYNC DISPLAY> button (up to 10
minutes between taps... seriously... that would be a long chase.)
3.4.3 Checking A Chase
1.
Press and hold the <PROGRAM> button until the PROGRAM LED blinks.
2.
Select the desired <CHASE> button
3.
Press the <TAPSYNC DISPLAY> button to switch the LED display to steps.
4.
Review each scene/step individually by using the <BANK UP>/<BANK DOWN>
buttons.
3.4.4 Edit A Chase (Copy A Bank Into A Chase)
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Press the desired <CHASE> button.
3.
Select the BANK to be copied using the <BANK UP>/<BANK DOWN> buttons.
4.
Press<MUSIC/BANK COPY> button to prepare to copy.
5.
Press <MIDI/ADD> button to copy the bank. All LEDs will blink.
3.4.5 Edit A Chase (Copy A Scene Into A Chase)
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Press the desired <CHASE> button.
3.
Select the BANK that contains the scene to be copied using the <BANK
UP>/<BANK DOWN> buttons.
4.
Press the <SCENE> button that corresponds to the scene to be copied.
5.
Press <MIDI/ADD> button to copy the scene. All LEDs will blink.
3.4.6 Edit A Chase (Insert A Scene Into A Chase)
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Press the desired <CHASE> button.
3.
Press the <TAPSYNC DISPLAY> button to switch the LED display to steps.
4.
Use the <BANK UP>/<BANK DOWN> buttons to navitage between steps and
locate the insert point for the new scene. The display will read the step number (
0-
240
)
5.
Press <MIDI/ADD> button to prepare the insert.
6.
Use the <BANK UP>/<BANK DOWN> buttons to locate the scene to insert.
7.
Press the <SCENE> button that corresponds to the scene to be inserted.
8.
Press <MIDI/ADD> button to insert the scene. All LEDs will blink.
3.4.7 Delete A Scene In A Chase
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Press the desired <CHASE> button.
3.
Press the <TAPSYNC DISPLAY> button to switch the LED display to steps.
4.
Use the <BANK UP>/<BANK DOWN> buttons to navitage between steps and
locate the scene to be deleted. The display will read the step number (
0-240
)
5.
Press the <AUTO/DEL> button to delete the scene/step. All LEDs will blink.