Getting started, 1 what’s in the box, 2 getting it out of the box – Blizzard Lighting SnoKontrol (Rev B) User Manual

Page 4: 3 powering up, 4 getting a hold of us, Getting, Started 3, What’s, Powering, Hold

Advertising
background image

SNOKONTROL Manual Rev B.

Page 4

Copyright © 2010-2013 Blizzard Lighting, LLC.

ALL RIGHTS RESERVED

1. GETTING STARTED

1.1 What’s In The Box?

1x SNOKONTROL™ DMX Controller

1x 12 VDC, 500ma AC/DC Adaptor

A Warranty Card & Warranty Info

This Lovely User Manual

1.2 Getting It Out Of The Box

We could tell just by lookin’ atcha. You’re a bit of a control freak, aren’t ya? Just kidding! CON-

GRATULATIONS! You’ve purchased a GREAT little DMX controller! Bravo! Now that you’ve got

your SNOKONTROL™, you should carefully unpack the box and check the contents to ensure that

all parts are present and in good condition. If anything looks as if it has been damaged in transit,

notify the shipper immediately and keep the packing material for inspection. Again, please save

the carton and all packing materials. If a fixture must be returned to the factory, it is important

that the fixture be returned in the original factory box and packing.

1.3 Powering Up!

All fixtures must be powered directly off a switched circuit and cannot be run off a

rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel

is used solely for a 0% to 100% switch.

AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the fixture

you receive is suitable for your local power supply. See the label on the fixture or refer to the

fixture’s specifications chart for more information. A fixture’s listed current rating is its average

current draw under normal conditions. Check the fixture or device carefully to make sure that if

a voltage selection switch exists that it is set to the correct line voltage you will use.

Warning! Verify that the voltage select switch on your unit matches the line voltage

applied. Damage to your fixture may result if the line voltage applied does not match

the voltage indicated on the voltage selector switch. All fixtures must be connected to

circuits with a suitable Ground (Earthing).

1.4 Getting A Hold Of Us

If something is wrong, just give us a call or send an email. We’ll be happy to help, honest.

Blizzard Lighting

W220 N1531 Jericho Ct. Suite E, Waukesha, WI 53186 USA

[email protected] | Phone: 866-493-6025

www.blizzardlighting.com

Advertising