8 delete a scene in a chase, 9 delete all chase programs, 5 scene programming (step programming) – Blizzard Lighting SnoKontrol (Rev B) User Manual
Page 14: 1 insert a scene, 2 copy a scene, 3 delete a scene, Delete, Scene, Chase, Programs
SNOKONTROL Manual Rev B.
Page 14
Copyright © 2010-2013 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
3.4.8 Delete A Scene In A Chase
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Press the desired <CHASE> button.
3.
Press and hold the <AUTO/DEL> button and the respective <CHASE> button to
delete the chase. All LEDs will blink.
3.4.9 Delete All Chase Programs
CAUTION! This procedure will result in irrevocable loss of chase step memory. The individual
scenes and program banks will be preserved.
1.
Turn the controller OFF.
2.
Press and hold the <BANK DOWN> button and the <AUTO/DEL> button while
turning the controller ON.
3.
All LEDs will blink for confirmation.
3.5 Scene Programming (Step Programming)
3.5.1 Insert A Scene
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Press the desired <CHASE> button.
3.
Press the <TAPSYNC DISPLAY> button to switch the LED display to step view.
4.
Use the <BANK UP>/<BANK DOWN> buttons to navitage between steps and
locate the insert point for the new scene. The display will read the step number (
0-
240
)
5.
Press <MIDI/ADD> button to prepare the insert.
6.
Use the <BANK UP>/<BANK DOWN> buttons to locate the scene to insert.
7.
Press the <SCENE> button that corresponds to the scene to be inserted.
8.
Press <MIDI/ADD> button to insert the scene. All LEDs will blink.
3.5.2 Copy A Scene
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Select the BANK that contains the scene to be copied using the <BANK
UP>/<BANK DOWN> buttons.
3.
Press the <SCENE> button that corresponds to the scene to be copied.
4.
Press <MIDI/ADD> button to copy the scene.
5.
Select the destination BANK to receive the copied data using the <BANK
UP>/<BANK DOWN> buttons.
6.
Press the <SCENE> button to complete the copy. All LEDs will blink.
3.5.3 Delete A Scene
1.
Press and hold the <PROGRAM> button to enter programming mode.
2.
Select the BANK that contains the scene to be deleted using the <BANK
UP>/<BANK DOWN> buttons.
3.
Press the <AUTO/DEL> button to delete the scene/step.
4.
Press the <SCENE> button that corresponds to the scene you want to delete. All
LEDs will blink.