3 delete all scenes, 6 playback, 1 sound active mode – Blizzard Lighting SnoKontrol (Rev B) User Manual
Page 15: 2 auto mode, 3 blackout, 7 midi operation, Delete, Scenes, Playback 14, Sound
SNOKONTROL Manual Rev B.
Page 15
3.5.3 Delete All Scenes
CAUTION! This procedure will result in irrevocable loss of scene data.
1.
Press and hold the <PROGRAM> and <BANK DOWN> buttons while switching
the controller OFF.
2.
Turn the controller back ON.
3.6 Playback
3.6.1 Sound Active Mode
In Sound Active mode, programs will be triggered by the built-in microphone.
1.
Press the <MUSIC BANK COPY> button until the MUSIC LED is lit.
2.
Select the BANK to run in sound active mode using the <BANK UP>/<BANK
DOWN> buttons.
3.
Alternately, you can press a single <CHASE> button (1-6) or several <CHASE>
buttons in sequence, and all selected chases will loop in the order in which they
were selected.
4.
Fade time may be adjusted using the FADE TIME fader.
3.6.2 Auto Mode
In Sound Active mode, programs will be triggered by the built-in microphone.
1.
Press <AUTO/DEL> button until the AUTO LED is lit.
2.
If a <CHASE> button is not pressed, SNOKONTROL will automatically run a BANK
program.
3.
Change BANK programs by using the <BANK UP>/<BANK DOWN> buttons.
4.
Alternately, you can press a single <CHASE> button (1-6) or several <CHASE>
buttons in sequence, and all selected chases will loop in the order in which they
were selected.
5.
Program speed may be adjusted using the SPEED fader. Fade time may be adjust-
ed using the FADE TIME fader.
3.6.3 Blackout
The <BLACKOUT> button brings all lighting output to ZERO (OFF).
3.7 MIDI Operation
The controller will only respond to MIDI commands on the MIDI channel which it is set to full
stop. All MIDI control is performed using Note on commands. All other MIDI instructions are ig-
nored. To stop a chase, send the blackout on note.
1.
Press and hold the <MIDI/ADD> button for at least 3 seconds.
2.
Select the MIDI control channel (1~16) via the <BANK UP>/<BANK DOWN>
buttons to set.
3.
Press and hold the <MIDI/ADD> button for 3 seconds to save settings.
4.
To release MIDI control, press any other button except the <BANK> buttons during
step 2.