Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 14)

3
PMT INSTALLATION
Intr
odu
ctio
n
Par
ts D
escription
Op
era
ting
Ins
tru
ctio
ns
Inte
rne
t U
pda
tes
App
end
ix
(To OBDII Adapter Plug)
(To Vehicle Fuse Box)
Cradle Cable
Custom A-Pillar Mount
with Cradle
Custom A-Pillar Pod Mount Diagram
Power Wire
Custom A-Pillar Pod
(Not Included)
TIGHTeNING THe CUsTOM a-pILLaR MOUNT sCReWs TIp
The four screws included with the Custom A-Pillar Mount work in pairs to perform two different
functions in securing the cradle to the Custom A-Pillar Mount. See the diagram below for details in
tightening the screws properly.
These two screw locations
tighten the mount to the A-
Pillar itself. Only completely
tighten these screws down
when the mount is in the
A-pillar and the A-pillar is
installed on the vehicle. These two screw locations
tighten the front and back
mounting plates together
to create a tight fit over the
cradle ball. Use these two
screws to adjust the tight-
ness of the swivel effect of
the cradle in the mount.
PM
T In
sta
llati
on