Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 28)

27
PMT INSTALLATION
Intr
odu
ctio
n
Par
ts D
escription
Op
era
ting
Ins
tru
ctio
ns
Inte
rne
t U
pda
tes
App
end
ix
seCTION 5: HOW TO DOCK THe pMT
(make sure that the vehicle key is off)
The PMT and cradle can be damaged if the PMT is not carefully placed onto the cradle. See the
diagrams below for proper installation. Note that the diagrams show the PMT being docked on to
the dash/windshield mounting styles, but the PMT docking instructions are the same for the A-Pillar
mount as well.
1. Make sure that the docking port on the bottom
part of the cradle is flipped forward as far as it
will go.
2. Dock the PMT onto the cradle.
3. Once docked, rotate the PMT back and snap it
into the cradle.
Removing the PMT:
1. When removing the PMT, simply press down on the top part of the PMT that snaps into the top of
the cradle.
2. Rotate the PMT forward on the docking port.
3. Pull the PMT up and out of the cradle.
Note: Check the cradle swivel to make sure that
it is connecting up to the PMT correctly. The bot-
tom of the swivel should be flush with the bottom
of the PMT.
PM
T In
sta
llati
on