Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 7)

6
Intr
odu
ctio
n
PM
T In
sta
llati
on
Op
era
ting
Ins
tru
ctio
ns
Inte
rne
t U
pda
tes
App
end
ix
pyrometer Connection Head (pCH) Board assembly
The PCH Board or Pyrometer Connection Head serves as a dock to connect the pyrometers into the PMT
system. The PCH Board includes the ability to connect two pyrometers. Attached to the PCH Board housing
is a cable with four pin plug which connects to the OBDII Adapter Plug. The list below includes all separate
parts that make up the entire PCH Board Assembly.
• PCH Board
• Velcro
• (2) Self-tapping Sheet Metal Screws
• Pyrometer Cable
Dash/Windshield Mounting assembly
This mounting assembly is recommended mainly for use on the dash of the vehicle, but can also be used in
the same manner on the windshield of the vehicle. The assembly includes all parts and pieces necessary to
mount the cradle, along with the PMT to the vehicle dash or windshield. The list below includes all parts and
pieces of this assembly (must be assembled by installer):
• Mounting Base
• Top Cradle Arm
• Bottom Cradle Arm
• Top Aluminum Plate
• Bottom Steel Plate (threaded)
• (2) Flat-head Screws
• Double Stick Foam Tape.
PARTS DESCRIPTION
Par
ts D
escription