Sentral connection – ClearCube I/Port Users Guide User Manual
Page 35
• 25
1. Ensure that you have connected devices as described in "
2. Connect the chassis to a network switch.
a.
Connect one end of a CAT5 or CAT6 Ethernet cable to the appropriate port on your
chassis.
•
R4300 chassis—Insert the cable in the Secondary Network port.
•
A3100 chassis—Insert the cable in the PCoIP port.
b. Connect the other end of the cable to a network switch on a known subnet.
3. Connect the I9420 I/Port to a network switch.
a.
Connect one end of a CAT5 or CAT6 Ethernet cable to the RJ-45 connector on the
I9420.
b. Connect the other end of the cable to a network switch on the same subnet as the
chassis. This switch can be the same switch used in step
.
4. Configure the I9420.
a.
Briefly press and hold the power button on the front of the I9420 to start it.
b. In the upper–left corner of the screen, click Options > Configuration to open the
Configuration window. From the Network tab, select the Enable DHCP option. Click
Apply and then click OK.
c.
From the Discovery tab, select the Enable Discovery and Enable Host Discovery
options. Click Apply and then click OK.
Your I9420 I/Port is now configured to discover blades automatically.
5. Provision the V5120 Dual Host card on the blade.
a.
From the I9420 desktop, click the Connect button to display the Discovered Hosts
dialog box. Record the IP address and MAC address of the blade’s V5120 Dual Host
card, or host, and then click Cancel to close the dialog box.
b. Open a Web browser on a computer with DHCP enabled, connected to the same
switch as the V5120 Dual Host card you are provisioning. To open the PCoIP Web
interface on the V5120, type the IP address that you recorded in the previous step in
the browser.
c.
From the Tera1202 PCoIP Processor menu, click Configuration > Monitor
Emulation. Select the monitor emulation option for both monitors (DVI 1 and DVI 2).
d. Click Apply and then click Continue.
e.
Click Configuration > Discovery and select the Enable Discovery option.
f.
Click Apply to save your changes and a success message is displayed. Click Reset
and then click OK to reset your blade and apply your changes.
g. Close the browser.
6. Return to the I9420 I/Port and click Connect to display the Discovered Hosts dialog box.
7. Click OK to connect your configured I9420 I/Port and blade.
Sentral Connection
When you use Sentral to manage I9420 I/Ports and hosts, Sentral sets IP addresses and session
controls according to device MAC addresses and the assignments that the administrator
specifies. See Sentral Administrator’s Guide for information about using Sentral to manage
hosts and thin clients.