Metrohm NIRS XDS MultiVial Analyzer - Manual (Page 57)

▪▪▪▪▪▪▪ 55
To reset the mechanism for MultiVial trays, select
Configure, Tray to return to the Select Tray dialog
box, and re-select “Use Tray”.
Use Boat:
If the user needs to scan a sample using the large
Sample Cell (boat), this box should be clicked. (This
resets the choice made in the “Select Tray” dialog
box.)
The user should remove the tray. Vision will position
the tray mechanism out of the way, to allow the
sample cell to be inserted.
When finished, the sample cell should be removed,
and the tray re-inserted into the MultiVial mechanism.
Failure to remove the Sample Cell may cause an error
to be reported in Vision.
To reset the mechanism for MultiVial trays, select Configure, Tray to return to the Select Tray dialog
box, and re-select “Use Tray”. (This was illustrated in the section immediately preceding this one.)
OK:
The “OK” button saves the settings made and closes the dialog box. When the user initiates a sample
scan, the information in the dial box will be applied.
Clear: