Metrohm 872 Extension Module Sample Prep - Manual (Page 20)

3.6 Connecting the extension module ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭ 872 Extension Modul – Sample Prep
3 Mounting covering plate
￭ Place covering plate on the extension module.
￭ Insert the cylinder screws (5-1) and screw tight with the 3 mm
hexagon key.
￭ Insert covering stoppers (5-2).
3.6 Connecting the extension module
In Out
Made by Metrohm Herisau Switzerland
1 2
Figure 6 Rear of the instrument
1 Connector In
To connect the extension module to the IC
instrument or to a previous extension mod-
ule. 2 Connector Out
To connect an additional extension module.
3.6.1 Connecting the extension module
Caution
The 850 Professional IC instrument must be switched off before the
extension modules are connected!
Connecting the extension module to the IC instrument
1 Plug cable 6.2156.060 into the connector In (6-1) of the extension
module and screw it tight.
2 Plug the other end of the cable into the Extension module connec-
tor of the IC instrument and screw it tight.