E-flite Ultra Stick 25e ARF User Manual
Page 20
Advertising
5. Bend the pushrod wire 90 degrees at the
mark made in the last step. Enlarge the outer hole
of the servo arm using a 5/64" (2mm) drill bit.
Slide the wire through the servo arm. Secure the
pushrod wire using a pushrod connector.
Note:.Use.side.cutters.to.trim.down.the.excess.
pushrod.wire.and.remove.the.extra.arms.from.
the.servo.horn.
6. Repeat Steps 1 through 5 for the remaining
aileron linkage installation.
20
Advertising