E-flite Ultra Stick 25e ARF User Manual
Page 28
Advertising
5. Bend the pushrod wire at the mark made
in the previous step. Enlarge the hole in the
servo arm using a 5/64" (2mm) drill bit.
Secure the pushrod wire to the servo horn using
a pushrod connector.
Note:.Use.side.cutters.to.trim.down.the.excess.
pushrod.wire.and.remove.the.extra.arms.from.
the.servo.horn.
6. Repeat Steps 3 through 5 for the elevator
pushrod wire.
28
Advertising