E-flite Ultra Stick 25e ARF - Manual (Page 24)

 6. Follow the procedure outline in the aileron
section to mark the pushrod, bend it and attach
it to the servo horn.
Note:.Use.side.cutters.to.trim.down.the.excess.
pushrod.wire.and.remove.the.extra.arms.from.
the.servo.horn.
 7. Use a hobby knife or razor saw to separate the
aileron from the flap. Use the covering provided
with the model to seal the ends where the two
were separated.
Note:.See.our.Ultra.Stick.25e.website.page.
for.radio.tips.for.quad.flap.operation.using.this.
setup..There.are.also.options.listed.if.you.use.
a.6-channel.transmitter.and.receiver..However,.
this.method.will.require.the.purchase.of.a.
reversed.servo.and.the.use.of.a.Y-harness.to.
connect.your.two.inner.location.servos.
24