Bunn LCR-3 User Manual
Page 8
8
OPERATING CONTROLS AND INTERFACE
1. Master ON/OFF Switch: Disconnects AC Power to the dispenser.
2. Hot Water Handle: Pull and Hold to dispense hot water manually.
3. Door Interlock Switch: Unit will not dispense product if the door is open.
4. LCD Display: Displays status, programming menus and fault messages.
5. Volume Selection: Rotate dial to the desired volume prior to dispensing product.
6. Dispense Switches (A-B-C): Push and Release to dispense the desired product.
(These also double as programming switches in the Set-Up mode).
7. Function Selector Switch: Allows the user to set the dispenser into different dispensing modes.
a. RINSE: Dispenses hot water only - Flushes the mix chamber and dispense tip.
b. RUN: Normal dispense mode - Dispenses mixed product (concentrate and water).
c. PRIME: Dispenses concentrate only – Primes the concentrate pump.
8. Hidden Set-Up / Programming switches.
a. Press and hold the Right switch for 5 sec. to enter in the Set-Up mode.
b. Use the Right switch to scroll down and the Left switch to scroll up through the menu screens.
4
8
6
7
5
3
2
1
41129 052208