Kessler MOTION CONTROL: Oracle Controller Full (3.02 SL) - Manual (Page 10)

CAMERA
This function allows you to control your camera through the
Oracle controller. You must have the Kessler Crane Camera Control
Module for this to function.
Pictures: The number of pictures that will be taken over the specified
Time Lapse period
Exposure Time: The time that the shutter is open for each photo
Shutter Delay: The time that the shutter is closed between each
photo that is taken
1. Enter Camera mode by selecting Camera from the
main Menu
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
2. Select Camera Setup
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
Note:
You can move the joystick LEFT/RIGHT to navigate through sub-menus
4. Change Exposure Time values by moving the joystick
UP/DOWN
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
Camera <
Motion Control v
Camera Setup <
Intervmtr Start
5. Change Shutter Delay values by moving the joystick
UP/DOWN
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
Note:
Use 0.50 seconds or more for most applications. If you use a faster
shutter delay (ex. 0.25 s), your camera may not be able to recover fast
enough.
5. Select Intervmtr Start by moving the joystick
UP/DOWN
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
6. Change Pictures/Run Time values by moving the
joystick UP/DOWN
Press ENTER or the MIDDLE JOYSTICK BUTTON to confirm
Shutter Delay
0.50 S
Camera Setup
Intervmtr Start <
Exposure Time
1.00 S
Run Time 33M 20S
Pictures 1000
10